User Guide User guide
Table Of Contents
- What is VN-MATRIX?
- Functional Overview
- Example System Application
- Front Panel Features
- Rear Panel Features
- Accessories
- Choosing a Suitable Location
- Mains Power Connection (via PSU)
- Mains Power Cord (for PSU)
- Setup and Connection Procedure
- The VN-MATRIX Web Interface
- Configuring a VN-MATRIX as an Encoder (source)
- Configuring a VN-MATRIX as a Decoder (display)
- Troubleshooting
- Encoder Set Up
- Decoder Set Up
- System Set Up
- Overview
- Setting-up a Serial Data Stream
- Setting-up a Serial Passthrough Group
- Setting-up a Remote Control Group
- Serial / Telnet Commands
- Overview
- VN-MATRIX Hardware
- Serial Interface – Quick Reference
- Telnet Interface – Quick Reference
- Web Interface – Quick Reference
- Network Characteristics
VN-MATRIX User Guide Section 3: System Configuration
I458GB issue 6 Page 51
Configuring a VN-MATRIX as a Decoder (display)
The following procedure assumes that at least one VN-MATRIX encoder has been configured and is
ready to stream a source (see page 46)
It is also assumed that a suitable display device is connected to the VN-MATRIX.
For details on how to connect a display, see pages 39 and 40.
NOTE: This procedure provides a basic level of configuration which will be adequate for most
systems. For additional ‘Advanced Setup’ options, see pages 74 to 81.
HINT: You can change the default device Name to be
more relevant to the source input (e.g. Screen1).
NOTE: Device names can use letters and numbers, as
well as the underscore and hyphen characters, but must
not include spaces.
n
On the Device List page click the
device that you want to configure.
The Device page will then appear…
o
Click the create display button.
Turn to page 52.