User Guide User guide
Table Of Contents
- What is VN-MATRIX?
- Functional Overview
- Example System Application
- Front Panel Features
- Rear Panel Features
- Accessories
- Choosing a Suitable Location
- Mains Power Connection (via PSU)
- Mains Power Cord (for PSU)
- Setup and Connection Procedure
- The VN-MATRIX Web Interface
- Configuring a VN-MATRIX as an Encoder (source)
- Configuring a VN-MATRIX as a Decoder (display)
- Troubleshooting
- Encoder Set Up
- Decoder Set Up
- System Set Up
- Overview
- Setting-up a Serial Data Stream
- Setting-up a Serial Passthrough Group
- Setting-up a Remote Control Group
- Serial / Telnet Commands
- Overview
- VN-MATRIX Hardware
- Serial Interface – Quick Reference
- Telnet Interface – Quick Reference
- Web Interface – Quick Reference
- Network Characteristics
Section 2: Installation & Basic Setup Procedures VN-MATRIX User Guide
Page 36 I458GB issue 6
Network Connection
CAUTION: Do not proceed with connecting VN-MATRIX to an existing network until it is correctly
configured using the procedure in Stage 1 (See pages 32 to 34). Incorrect connection or configuration
may cause disruption to other network users.
Typically, the VN-MATRIX will connect to convenient network point on an existing in-house network.
Use a standard CAT 5E or CAT 6 (or better) patch cable for this purpose. A patch cable is not
supplied with the VN-MATRIX but is readily available in a variety of lengths from all good computer
suppliers.
If a convenient network point is not available it will be necessary to have one installed – please
consult the IT/Network Administrator or Building Facilities Manager for advice. Alternatively, the VN-
MATRIX and source computer can ‘share’ a connection by using a switcher. Hubs are not suitable for
use with VN-MATRIX as they restrict bandwidth.
For normal VN-MATRIX operation use Network Port I only.
HINT: With the VN-MATRIX powered and connected to a network the Network Status Indicator
(next to the network connector) should be lit: