User Guide User guide
Table Of Contents
- What is VN-MATRIX?
- Functional Overview
- Example System Application
- Front Panel Features
- Rear Panel Features
- Accessories
- Choosing a Suitable Location
- Mains Power Connection (via PSU)
- Mains Power Cord (for PSU)
- Setup and Connection Procedure
- The VN-MATRIX Web Interface
- Configuring a VN-MATRIX as an Encoder (source)
- Configuring a VN-MATRIX as a Decoder (display)
- Troubleshooting
- Encoder Set Up
- Decoder Set Up
- System Set Up
- Overview
- Setting-up a Serial Data Stream
- Setting-up a Serial Passthrough Group
- Setting-up a Remote Control Group
- Serial / Telnet Commands
- Overview
- VN-MATRIX Hardware
- Serial Interface – Quick Reference
- Telnet Interface – Quick Reference
- Web Interface – Quick Reference
- Network Characteristics
VN-MATRIX User Guide Section 7: Technical Data
I458GB issue 6 Page 109
Device List Page
Use this page to:
Select a device to configure (click on the appropriate device link)
Save all current device settings (click the Save All tab)
Switch to the Accounts page (click the Accounts tab)
Refresh the device listing (click the Device List tab)
The current configuration status of each device is also identified by an icon:
unconfigured
a VN-MATRIX configured as a decoder (display)
a VN-MATRIX configured as an encoder (source)
a computer configured as a VN-MATRIX Recorder
NOTE: Once a VN-MATRIX device has been detected and been listed on the Device List, an
entry will be displayed even if the device is subsequently disconnected. All valid devices are listed
by device name and followed by their current IP address. ‘Offline’ devices (that couldn’t be
contacted by the controller) are easily identified by the lack of an IP Address. In the above
example, ‘device620098’ is currently offline.
For further information:
Refer to the online help (click the Help tab)