User Guide User guide
Table Of Contents
- What is VN-MATRIX?
- Functional Overview
- Example System Application
- Front Panel Features
- Rear Panel Features
- Accessories
- Choosing a Suitable Location
- Mains Power Connection (via PSU)
- Mains Power Cord (for PSU)
- Setup and Connection Procedure
- The VN-MATRIX Web Interface
- Configuring a VN-MATRIX as an Encoder (source)
- Configuring a VN-MATRIX as a Decoder (display)
- Troubleshooting
- Encoder Set Up
- Decoder Set Up
- System Set Up
- Overview
- Setting-up a Serial Data Stream
- Setting-up a Serial Passthrough Group
- Setting-up a Remote Control Group
- Serial / Telnet Commands
- Overview
- VN-MATRIX Hardware
- Serial Interface – Quick Reference
- Telnet Interface – Quick Reference
- Web Interface – Quick Reference
- Network Characteristics
Section 7: Technical Data VN-MATRIX User Guide
Page 106 I458GB issue 6
Telnet Interface – Quick Reference
Starting Telnet
Click the Windows Start button and click on Run.
In the Open box type telnet then press the<enter> key.
The telnet application will start in a separate window:
Login Procedure
At the prompt type open followed by the ip address of the VN-MATRIX controller and the telnet
port number (9999), then press <enter>. For example:
open 192.168.0.18 9999 <enter>
At the command: prompt type user admin, then press <enter>.
Then type pass followed by a space and the appropriate password, then press <enter>.
By default the password is admin, but this can be changed via the web interface, see page 81).
Type further commands as required (see pages 93 to 95 for command options).
To logout type exit followed by <enter>.