User Guide Owner's manual

Configuring the Decoder Data
11
2
2
Figure 63. Decoder Data Bandwidth Link
1. In the Display tab, ensure that the Data check box (see figure 63,
1
) is selected.
2. Click the bandwidth data link (see figure 63,
2
). The Bandwidth (data) tab opens.
This is the same as the Bandwidth (audio) tab but has an Data Control panel (see
figure64):
11
2
23344
Figure 64. Bandwidth (data) Tab
3. If required, check the Serial Enable (see figure 64,
1
) and UDP Enable (see
figure64,
2
) check boxes, and enter the UDPIPaddress (see figure 64,
3
) and
UDP Port number (see figure 64,
4
). (For more information about these choices, see
Decoder data bandwidth tab on page 64.)
4. Save the changes by clicking Save All.
VNM 250 • Configuration with the VNM 250 GUI 76