User Guide Owner's manual

Configuring the Decoder Audio
11
2
2
Figure 61. Decoder Audio Bandwidth Link
1. In the Display tab, ensure that the Audio check box (see figure 61,
1
) is selected.
2. Click the bandwidth audio link (see figure 61,
2
). The Bandwidth (audio) tab opens.
This is the same as the Bandwidth (video) tab but has an Audio Control panel (see
figure62):
11
2
2
3
3
Figure 62. Bandwidth (audio) Tab
3. Select the appropriate check boxes to output the received audio stream to the HDMI
port, the Analog output port or both (see figure 62,
1
).
4. The analog audio output level is controlled using Analog Output Level (see
figure62,
2
). The output level is correct if the input level on the encoder was correctly
configured for optimum signal.
5. Select the input level for the reverse audio, using Analog Input Level (see
figure62,
3
). Set the value just larger than the maximum value that will be input. (For
more information about the Bandwidth (audio) tab, see Decoder audio bandwidth
tab on page 62.)
6. Save the changes by clicking Save All.
NOTE:
• The active status information on this page updates only if the audio check
box is selected in step 1, above.
• If the check box was not selected, no audio signal is carried by the selected
stream and there will be no audio output by the VND 250, even if the HDMI or
Analog Audio boxes are selected.
VNM 250 • Configuration with the VNM 250 GUI 75