User Guide Owner's manual
4. If required, use the Framelock Ref drop‑down list (see figure 58,
3
) to set up
membership of a decoder genlock group (see Framelock Ref on page 59).
5. Select a video source from the Source drop‑down list (see figure 58,
4
).
6. If required, select the audio and data check boxes (see figure 58,
5
).
7. Click the Save All tab.
Monitoring the Decoder Video Bandwidth
11
2
2
Figure 59. Decoder Bandwidth (video) Link
1. In the Display tab, select a video source from the drop‑down list (see figure 59,
1
).
2. Click the video link (see figure 59,
2
). The Bandwidth (video) tab opens (see
figure60):
11
Figure 60. Bandwidth (video) Tab
3. Set the Channel Delay and Frame Delay (see figure 60,
1
). For more information
about the Bandwidth (video) tab, see Decoder video bandwidth tab on page 61.
4. Save the changes by clicking Save All.
NOTE: The active status information on the video Bandwidth page only updates if
a video source is selected in step 1 above.
VNM 250 • Configuration with the VNM 250 GUI 74