User Guide Owner's manual

Configuring the Decoder Display
1. In the Configuration panel, click on display0 (see figure 57,
1
):
11
Figure 57. Device Configuration Panel
The Display tab opens with display options (see figure 58). More information about the
Display tab can be found on page 58.
11
2
2
3
3
5
544
Figure 58. Display Tab
2. Set the Output Format from the drop‑down list (see figure 58,
1
):
z Auto — sets the display to the same resolution and refresh rate as the source
stream.
z Monitor — sets the decoder output mode to the preferred resolution and frame
rate of the output monitor. To operate correctly, this feature requires the monitor to
support EDID properly.
z Fixed — sets the decoder output mode to the chosen resolution and frame rate as
selected from the drop‑down list.
NOTE: The scale option must be enabled whenever Monitor or Fixed output
formats are selected.
3. Enable or disable the
Nodata Splash, SoG, Scale, Genlock, Clean Switch, and
HDCP Mode check boxes (see figure 58,
2
). For more information about these
check boxes, see page 58.
NOTE: The SoG mode is not supported by the VND 250. Selecting this option has
no effect.
VNM 250 • Configuration with the VNM 250 GUI 73