User Guide Owner's manual

Configuring Encoder Video
9. In the Configuration panel, click on VideoPort0 (see figure 47,
1
):
11
Figure 47. Device Configuration Panel
The Configure tab opens with video options.
1
11
2
2
3
3
4
4
5
5
Figure 48. Configure Tab (Video Options)
10. Ensure the Input Channel is set to auto (see figure 48,
1
).
11. Set the EDID (D) for the digital video input and the EDID (A) for the analog input, as
required (see figure 48,
2
).
12. If a digital source with HDCP is connected, ensure that the HDCP Authorize box is
selected (see figure 48,
3
).
13. Ensure the Current Mode shows the format of the connected source (see
figure48,
4
).
14. If RTP multicast source streaming is
required, select the Multicast Enable box
(see figure48,
5
). A dialog is displayed
asking for a multicast address (see the
figure to the right). This must be obtained
from your network administrator.
If RTP unicast is required, ensure the Multicast Enable box is deselected.
VNM 250 • Configuration with the VNM 250 GUI 67