User Guide Owner's manual

5. Select option 9 (Exit) to enter the Controller menu.

6. DHCPD/SLAAC server enable: none

9. Exit

Please select an option:

Figure 17. Low Level Conﬁguration Menu, Page 2

Ensure that options 6 is set to none.

6. Select option 9 (Exit) to reboot the device.

The streaming network settings will be conﬁgured when the VNM250 device is

connected to a network with a properly conﬁgured system controller or DHCP server.

NOTE: The VN‑Matrix Enterprise Controller does not currently provide DHCP

server functionality.

Using a Dedicated DHCP Server

If required, a dedicated DHCP server may be used to provide the IP address settings for the

VNM250 device in a system.

The device that is acting as the system controller must have its IP settings conﬁgured

statically.

The other VNM250 devices in the system are to be conﬁgured for DHCP as described in

Conﬁguring a VNM 250 Series Unit to Operate with a DHCP Server on the previous

page.

If possible, the DHCP server should be conﬁgured to provide the Controller IP address and

port number, using the Vendor Speciﬁc Option. Otherwise, the IP address of the system

controller must be entered on all VNM250 devices in the system.

VNM 250 • Low Level Device Conﬁguration 30