User Guide Owner's manual

Command ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
General
Query Firmware
version
Q
x.xx.xxx]
Firmware version as x.xx.xxx
(major.minor.build)
Query Part
Number
N
Pno xx-xxxx-xx]
Part number
60-1274-01 (encoder)
60-1275-01 (decoder)
Query Model
Name
I
VNE•250•Matrix]
or
VNE•250•Matrix]
Model name
VNE•250•Matrix
(encoder)
VND•250•Matrix
(decoder)
Absolute System
Reset
EZQQQ} Zpq]
Runs the sanitize feature (see
page 99) of the VNM250
Reboot System
E1BOOT} Boot1]
Saves and commits any
changes made to the network
settings
Restart Network
E2BOOT} Boot2]
Works in the same way
as Boot1. Currently, the
VNM250 does not support a
restart of network ports alone.
NOTES:
• Trying to set an IP address, subnet mask, or gateway address while DHCP is enabled, will result in an E14
(Invalid command for this configuration) error message.
• Using the CISG command (to set the IP address, subnet mask, and gateway address at the same time)
while DHCP is enabled, disables DHCP.
• Any changes to the network settings require a reboot to enforce them.
• Currently, SIS implementation by the VNM 250 supports only Extron Verbose mode 0.
• To comply with industry standards, there cannot be any "1" bits to the right of a "0" bit in a subnet mask.
For example, 255.255.128.0 (11111111.11111111.10000000.00000000) is valid;
255.255.64.0 (11111111.11111111.01000000.00000000) returns an E13 (Invalid value) error message.
VNM 250 • SIS Commands 128