User Guide Owner's manual

Command and Response Table for SIS Commands
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
Network
Set DHCP
EX57^*X%DH} IdhX57^*X%] X57^ = NIC card number
LAN1 = 1
LAN2 = 2
X% = DHCP status
0 = disabled
1 = enabled
Query DHCP
EX57^DH} X%]
Set IP address
EX57^*X1$CI} Ipi•X57^*X1$] X1$ = IP address
View IP address
EX57^CI} X1$]
Set Subnet mask
EX57^*X1(CS} Ips•X57^•X1(] X1( = Subnet mask
View subnet mask
EX57^CS} X1(]
Set gateway
address
EX57^*X1$CG} Ipg•X57^•X1$] X1$ = Gateway address
There is no gateway for
LAN 1 (control port); E14
error is returned.
View gateway
address
EX57^CG} X1$]
View MAC
address
EX57^CH} X1*] X1* = MAC address
Set Controller IP
EX1$SYSC} Sysc•X1$*X^] X1$ = IP address
X^ = Port number
Set Controller IP
and port
EX1$*X^SYSC} Sysc•X1$*X^]
View Controller IP
and port number
ESYSC} X1$*X^]
(Default value =
192.168.254.254*5432)
Set IP/Subnet/Gateway (at the same time)
Set IP address
EX57^*X1$CISG} Cisg•X57^*X1$*X1(*X1$] The first X1$ value is the IP
address and the second is the
Gateway address.
There is no gateway for LAN1
(control port); E14 error is
returned.
Set IP/Subnet
(IPv4)
EX57^*X1$*X1(CISG} Cisg•X57^*X1$*X1(*X1$]
Set IP/Subnet/
Gateway (IPv4)
EX57^*X1$*X1(*X1$CISG} Cisg•X57^*X1$*X1(*X1$]
View IP/Subnet/
Gateway
EX57^CISG} X1$*X1(*X1$]
VNM 250 • SIS Commands 127