User guide

Extender Plus Series • Installation and Operation 10

Mounting

Mounting the Extender Plus AAP

The Extender Plus AAP and any other adapter plates must be attached to a device

faceplate or AAP wall plate and cabled before the device or wall plate is installed in a wall or

furniture.

1. Before attaching any user-supplied cables, insert the Extender Plus AAP output BNC

connectors and wires through the opening in the front of the wall plate or device

faceplate.

ATTENTION: Potential damage to property. Be careful not to damage

connectors while placing the Extender through the opening.

2. Insert the threaded standoffs of the AAP through the holes in the device faceplate or

AAP wall plate.

3. Using the provided #4-40 nuts and captive washers, secure the Extender to the

faceplate or wall plate.

Installation Cable

Cable

Clamp

Screws or Nails

Wall Stud

Extender Plus AAP

AAP 102

#4-40 Nut w/ Captive

Washer

EXTENDER AAP Plus

COMPUTER IN

AUDIO IN

Figure 4. Mounting the Extender Plus AAP to a Device or Wall Plate

Connects to

AAP Cable

Two Screws

Each Side

Front Panel

HSA 822

#4-40 Nut