User`s manual
VersaTools
®
MTP 15HD RS Series • Installation
VersaTools
®
MTP 15HD RS Series, cont’d
VersaTools
®
MTP 15HD RS Series • Controls and Indicators
3
Peaking control — Peaking affects the sharpness of a picture.
Increased peaking can compensate for mid- and high-frequency
detail loss from low bandwidth system components or
capacitance in long cables. The minimum setting (at the
counterclockwise limit) provides no peaking. The maximum
setting (at the clockwise limit) provides 100% peaking. Adjust
this control while viewing the displayed image to obtain the
optimum picture sharpness.
4
Select button (SEQ model only) — This recessed button selects
the red, green, or blue video signal to adjust and resets all three
video signals to a skew delay of zero nanoseconds.
Use a Tweeker or small screwdriver to press and release this
button to cycle among selecting the red, green, or blue video
signal to adjust. The
selected signal is indicated by the Red,
Green, and Blue LEDs (
5
).
The SEQ receiver automatically saves the setting for the
video signal that is being deselected when you push this
button or when the selection times out after 10 seconds.
Press and hold this button for approximately 3 seconds to zero
the skew delay for red, green, and blue. The Red, Green, and
Blue LEDS (
5
) all turn off. Release the button.
5
Red, Green, and Blue LEDs (SEQ model only) — These LEDs
indicate the video signal that is selected by the Select button
(
4
) for skew adjustment using the Adjust control (
6
). The LED
for the selected color ashes when the skew compensation for
that color’s video signal has reached the minimum or maximum
limit.
6
Delay (skew adjustment) control (SEQ model only) —
This control delays the selected red, green, or blue video signal
by up to 62 nanoseconds. The delay is applied in incremental,
2-nanosecond, steps. Rotate the control counterclockwise to
reduce the delay or clockwise to increase the delay.
The control’s movement is smooth; it does not have
mechanical steps or high- and low-limit stops.
Watch the displayed image to observe the steps of delay.
The Red, Green, or Blue LED (
5
) (whichever is
selected) flashes to indicate that the control has reached
the minimum (counterclockwise rotation) or maximum
(clockwise rotation) limit.
22