User`s manual

VersaTools

MTP 15HD RS Series • Installation

VersaTools

MTP 15HD RS Series, cont’d

VersaTools

MTP 15HD RS Series • Connections and Settings

Video switch — Set this switch up for RsGsBs, RGsB,

component/S-video/composite video or down to output

RGBHV or RGBS video. See the table on page 17.

Set the Composite Sync, SOG, and Video DIP switches

as shown in the table on page 17 for the various input

and output video formats.

End Unit switch — Set this switch up if either of the following

is true:

• The receiver being congured is the only receiver

connected to the transmitter.

• The receiver being congured is the last receiver in a

daisy-chained system.

If one or more receivers are connected to the Buffered Output

RJ-45 connector of the receiver being congured, set that

receiver’s End Unit switch down.

Power supply wiring

Figure 10 shows how to wire the connector.

CAUTION

Power supply voltage polarity is critical. Incorrect

voltage polarity can damage the power supply and

the transmitter or receiver. Identify the power cord

negative lead by the ridges on the side of the cord.

To verify the polarity before connection, plug in the power

supply with no load and check the output with a voltmeter.

Power Supply

Output Cord

Captive Screw

Connector

SECTION A–A

Ridges

Smooth

A A

Tie Wrap

Figure 10 — Power connector wiring