User`s manual

VersaTools
®
MTP 15HD RS Series • Installation
Video and serial data connections and settings
4
Output video connector — Connect a
projector or other high resolution video device
to this 15-pin HD connector.
5
RS-232 connector — Connect a serial
communications port to this 3.5 mm, 3-pole captive screw
connector for bidirectional RS-232 communication. Wire the
connector as shown in gure 8 on page 14.
By default the RS-232 link is unidirectional only, from
the transmitter to the receiver. You can reconfigure the
receiver for bidirectional communication in a single-
receiver system only by changing the directional
jumper (see “Receiver Jumpering”, on page 6).
6
DIP switches
Horizontal Sync (H Sync +) switch — Set this
switch up for positive horizontal sync (or positive
composite sync if the Composite Sync switch is on)
or down for negative sync.
Vertical Sync (V Sync +) switch — Set this switch up for
positive vertical sync or down for negative sync.
For H Sync + and V Sync +, most devices use
negative sync.
Composite Sync (C Sync) switch — Set this switch up for RGBS
or down to output RGBHV or RGsB video. See the table below.
Output signal
format from
the receiver
Input signal
format to the
transmitter
Receiver's DIP
switch settings
C Sync SOG Video
RGBHV
RGBS RGBHV
RGsB
RGBS
RGsB
RGsB
Component
S-video
Composite
RGBS
RGsB
RsGsBs RsGsBs
Component
S-video
Composite
Sync-on-Green (SOG) switch — Set this switch up for RGsB
video (when the input is RGBHV or RGBS) or down to output
RGBHV, RsGsBs, or RGBS video. See the table above.
17VersaTools
®
MTP 15HD RS Series • Connections and Settings
51
15 11
610
Female
ON
1 2 3 4 5 6
H SYNC + V SYNC + C SYNC
SOG VIDEO END UNIT