User`s manual

VersaTools
®
MTP 15HD RS Series • Installation VersaTools
®
MTP 15HD RS Series • Connections and Settings
Connections and Settings
Transmitter
See gure 7 to identify the rear panel connections on the
transmitter.
OUTPUT
INPUT
POWER
12V
.5A MAX
Tx Rx
RS-232
MONITOR
PRE-PEAK
ON
OFF
MTP T 15HD RS
NOTE A “C7” label is affixed to
transmitters designed fo
r
CAT 7 cable.
6 5 1 3 2
4
Figure 7 — Transmitter’s rear panel features
Power connection
1
Power connector — Plug the included external 12 VDC power
supply into this 2-pole captive screw connector. See “Power
supply wiring” on page 18 to wire the connector.
Video and serial data connections
2
Input video connector — Connect a computer
video source to this 15-pin HD connector for
high resolution video input.
Input only sync signals, no video signals,
on the sync pins, 13 and 14.
For component video, use the R (R-Y) and R return pins
(pins 1 and 6), G (Y) and G return pins (pins 2 and 7),
and B (B-Y) and B return pins (pins 3 and 8).
For S-video, use the R, R return (C-chroma), G, and G
return (Y-luma) pins.
For composite video, use the G pin and the associated
return pin. For additional genlocked video signals, use
the R, B, and associated return pins.
3
Monitor connector — Connect a video monitor to this
15-pin HD connector for buffered, high resolution video
loop through.
13
51
15 11
610
Female