User`s manual

VersaTools
®
MTP 15HD RS Series • Installation
VersaTools
®
MTP 15HD RS Series, cont’d
VersaTools
®
MTP 15HD RS Series • Installation12
Furniture or projector mounting
Use the optional mounting kit (furniture, part #70-212-01, or
projector, part #70-217-01) to mount the MTP as follows (gure 6):
MTP S ERI ES
INPUT
OUTPUT
POW
ER
1
2
V
.5
A
M
A
X
MTP R 1 5H D A
O
N
1
2
3
4
5
6
H
S
Y
N
C
+
V
S
Y
N
C
+
C
S
Y
N
C
S
O
G
V
I
D
E
O
S
P
A
R
E
1
M
O
N
O
A
U
D
IO
2
Projector
PMK 100
Projector
Mounting
Bracket
MBU 123
Under-Desk
Mounting
Bracket
Mounting
Bolt
Figure 6 — Desk and projector mounting the MTPs
1. Remove the feet from the bottom of the MTP, if they are
installed.
2
. Attach the mounting brackets to the MTP with the
machine screws provided.
3
. For furniture mounting, hold the MTP with the attached
brackets against the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4
. For furniture mounting, drill 3/32" (2 mm) diameter pilot
holes, 1/4" (6.3 mm) deep in the mounting surface at the
marked screw locations.
5
. For furniture mounting, insert #8 wood screws into the
four pilot holes. Tighten each screw into the mounting surface
until just less than 1/4" (6 mm) of the screw head protrudes.
6. For furniture mounting, align the mounting screws with the
slots in the brackets and place the MTP against the surface,
with the screws through the bracket slots.
7
. For furniture mounting, slide the MTP slightly forward or
back, then tighten all four screws to secure the MTP in place.
8
. For projector mounting, secure the MTP to a projector mount
by inserting the mounting bolt through the
bracket’s slotted hole and tightening the bolt.