User`s manual

VersaTools
®
MTP 15HD RS Series • Installation
VersaTools
®
MTP 15HD RS Series, cont’d
Back of the rack mounting
The MTP can be mounted to the rear of a rack using the Extron
MBB 100 VersaTools back of the rack mounting kit
(part #70-367-01) (gure 4). The kit allows the product to be
vertically mounted to the front or rear rack supports and facing
either towards the front or the rear of the rack.
1
. If installed, remove feet from the bottom of the MTP.
2. Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3
. Attach one bracket to the side of the unit (gure 4) using the
longer screws included in the kit.
4
. Repeat steps 2 and 3 on the other side of the unit.
5
. Mount the unit to the rack using the two included rack
screws (gure 5). The MTP can be vertically mounted
facing in either direction.
MT P SE RIES
Figure 4 — Attaching the back of the rack kit
10