Setup Guide VersaTools® MTP Series Video and Audio Mini Twisted Pair Transmitters and Receivers 68-732-50 Rev.
Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
Precautions, cont’d 安全须知 • 中文 警告 这个符号提示用户该设备用户手册中 有重要的操作和维护说明。 电源 • 该 设 备 只 能 使 用 产 品 上 标 明 的 电 源 。 设 备 必须使用有地线的供电系统供电。 第三条线 （地线）是安全设施，不能不用或跳过。 这个符号警告用户该设备机壳内有暴 拔掉电源 • 为安全地从设备拔掉电源，请拔掉所有设备后 或桌面电源的电源线，或任何接到市电系统的电源线。 露的危险电压，有触电危险。 电源线保护 • 妥善布线， 避免被踩踏，或重物挤压。 注意 阅读说明书 • 用 户 使 用 该 设 备 前 必 须 阅 读 并 理 解所有安全和使用说明。 保存说明书 • 用户应保存安全说明书以备将来使 用。 遵守警告 • 用户应遵守产品和用户指南上的所有安 全和操作说明。 维护 • 所有维修必须由认证的维修人员进行。 设备内部 没有用户可以更换的零件。为避免出现触电危险不要自 己试图打开设备盖子维修该设备。 通风孔 • 有些设备机壳上有通风槽或孔，它们是用来防止 机内敏感元件过热。 不要用任何东西挡住通风孔。 锂电池 • 不正确的更换电池会有
Table of Contents Chapter One • Installation . .................................................. 1-1 About the MTP Transmitters and Receivers .................... 1-2 Signal Jumpers for Generational Compatibility . ........... 1-3 Mounting Options . .................................................................. 1-4 Frame mounting (AAP models) ............................................ 1-4 Furniture or projector mounting (except AAP models) .....
Table of Contents, cont’d All trademarks mentioned in this manual are the properties of their respective owners. 68-732-50 Rev. A 09 08 ii VersaTools ® MTP Series • Table of Contents Refer also to the VersaTools ® MTP Series User’s Manual at www.extron.com.
VersaTools ® MTP Series Series 1 Chapter One Installation About the MTP Transmitters and Receivers Signal Jumpers for Generational Compatibility Mounting Options Panel Features and Connections
Installation About the MTP Transmitters and Receivers The Extron MTP transmitters and receivers provide a system for long‑distance distribution of A/V signals over Category (CAT) 5 shielded (STP), unshielded (UTP), or foil shielded (FTP) twisted pair cable. They are part of the Extron VersaTools® line of basic distribution amplifiers, switchers, transmitters, receivers, and associated video accessories.
Signal Jumpers for Generational Compatibility The latest generation MTP transmitters convert stereo audio to mono before outputting it to the receiver. Remote powering of either the transmitter or receiver has also been eliminated.
Installation, cont’d Mounting Options Tabletop use (all except AAP models) The non-AAP MTP units come with self-adhesive rubber feet attached to the four corners of the bottom. Set the MTP on a horizontal surface. Rack mounting (all except AAP models) For rack mounting, use any of the rack shelves listed in the "Accessories" table in the Appendix, page A-2.
Panel Features and Connections Transmitter input connections Figure 1-1 shows the video and audio input connectors of the MTP Series transmitters. N Some transmitters do not have audio connections. INPUT L 12V 0.5a MAX R S-VIDEO c L c OUTPUT 12V 0.5a MAX MTP T SV A MTP T SV A, L 12V 0.
Installation, cont’d c Audio input captive screw connector (MTP T SV A, MTP T AV) — Connect a balanced or unbalanced audio input to this 3.5 mm, 5-pole captive screw connector. Connectors are included with each MTP. See Figure 1-2 to wire a connector for the appropriate input type. Use the supplied tie-wrap to strap the audio cable to the extended tail of the connector. High impedance is generally over 800 ohms.
Transmitter/receiver throughput connections See Figure 1-5 to identify the connections between the transmitter and receiver. MTP Transmitters MTP Receivers INPUT L 12V 0.5a MAX OUTPUT R S-VIDEO L OUTPUT 12V 0.5a MAX MTP T SV A RCA e L 12V 0.5a MAX S-VIDEO INPUT MTP R SV A RCA e INPUT R VIDEO R L OUTPUT 12V 0.5a MAX MTP T AV OUTPUT INPUT R VIDEO MTP R AV OUTPUT e − + POWER 12V 0.
Installation, cont’d Power connection (all models) See Figure 1-6 to identify the power connections and indicators. MTP Transmitters MTP Receivers INPUT L OUTPUT R L g R g 12V 0.5a MAX S-VIDEO OUTPUT 12V 0.5a MAX MTP T SV A RCA f S-VIDEO INPUT MTP R SV A RCA f g MTP AAP Transmitters OUTPUT − + POWER 12V 0.
C The length of exposed wires is critical. Ideal length is 3/16” (5 mm). If the stripped section of wire is longer than 3/16” the exposed wires may touch, causing a short circuit. If the stripped section of wire is shorter, wires can easily be pulled out even if tightly fastened by the captive screws. N Do not tin the stripped leads! Tinned wires are not as secure in the captive screw and direct insertion connectors and could be pulled out.
Installation, cont’d Receiver output connections Figure 1-8 shows all combinations of rear panel output connections for the MTP receivers. MTP R SV A, Rear Panel OUTPUT L j 12V 0.5a MAX MTP R SV A RCA, Rear Panel R k h S-VIDEO INPUT MTP R AV, Rear Panel j 12V 0.5a MAX L 12V 0.5a MAX MTP R SV A L OUTPUT R S-VIDEO INPUT MTP R SV A RCA MTP R AV RCA, Rear Panel OUTPUT R INPUT OUTPUT k i VIDEO MTP R AV L 12V 0.
VersaTools ® MTP Series Series 2 Chapter Two Operation Front Panel Features Troubleshooting — Skew Delay Compensation
Front Panel Operation Front Panel Features a cb SHARP Y GAIN a C GAIN MTP R S-video Receiver Front Panel SHARP GAIN MTP R Composite Video Receiver Front Panel cc b Figure 2-1 — MTP receiver front panels a Power LED — When lit, this LED indicates power is applied to the MTP. b Sharpness — Adjusts output image sharpness to compensate for long cable runs. c Gain control — Adjusts the brightness of the output image to compensate for long cable runs.
VersaTools ® MTP Series Series A Appendix A Reference Information Specifications Part Numbers
Specifications, Part Numbers, and Accessories Specifications Consult the VersaTools User's Manual on the included CD ROM or at www.extron.com for a complete list of specifications. Please consult the VersaTools User's Manual found at www.extron.com or on the included CD ROM for a complete list of optional accessories, pre-cut cables, connectors and bulk cable. For highest quality, reliability and compatibility always use Extron cable, connectors, and bulk cable.
MTP transmitters Description Part number MTP T SV 60-540-42 MTP T SV A 60-540-52 MTP T SV A RCA 60-540-62 MTP T SV A AAP (black, white) 70-362-22, 23 MTP T CV 60-540-41 MTP T AV 60-540-51 MTP T AV RCA 60-540-61 MTP T AV AAP (black, white) 70-361-22, 23 MTP receivers Description Part number MTP R SV 60-541-42 MTP R SV A 60-541-52 MTP R SV A RCA 60-541-62 MTP R CV 60-541-41 MTP R AV 60-541-51 MTP R AV RCA 60-541-61 AAP accessories Accessory Part number AAP 102 panel (gray, bl
Specifications, Part Numbers, Accessories, cont’d Cables/connectors N Enhanced Skew-Free™ A/V UTP cables are not recommended for Ethernet/LAN applications.
Extron’s Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purchase.
Extron USA - West Headquarters +800.633.9876 Inside USA / Canada Only +1.714.491.1500 +1.714.491.1517 FAX Extron USA - East Extron EMEA Extron Asia Extron Japan Extron China Extron Middle East +800.633.9876 +800.3987.6673 +800.7339.8766 +81.3.3511.7655 +81.3.3511.7656 FAX +400.883.1568 +971.4.2991800 +971.4.2991880 FAX +1.919.863.1794 +1.919.863.1797 FAX +31.33.453.4040 +31.33.453.4050 FAX +65.6383.4400 +65.6383.
