User`s guide

VersaTools
®
MTP Series • Installation
VersaTools
®
MTP Series • Installation
Installation, cont’d
2-52-4
Furniture or projector mounting
(all except AAP and 45 models)
Use the optional mounting kit (furniture, part #70-212-01, or
projector, part #70-217-01) to mount the MTP as follows:
1. Remove the feet from the bottom of the MTP, if installed.
2. Attach the mounting brackets to the MTP with the
machine screws provided (figure 2-3).
Under Desk Mounting Projector Mounting
Ceiling
Projector
Projector
Mounting
Bracket
Mounting
Bolt
Figure 2-3 — Desk and projector mounting the MTPs
3. For furniture mounting —
a. Hold the MTP with the attached brackets against the
underside of the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
b. Drill 3/32" (2 mm) diameter pilot holes, 1/4"
(6.3 mm) deep in the mounting surface at the marked
screw locations.
c. Insert #8 wood screws into the four pilot holes.
Tighten each screw into the mounting surface until
just less than 1/4" of the screw head protrudes.
d. Align the mounting screws with the slots in the
brackets and place the MTP against the surface, with
the screws through the bracket slots.
e. Slide the MTP slightly forward or back, then tighten
all four screws to secure the MTP in place.
4. For projector mounting, secure the MTP to a projector
mount by inserting the mounting bolt through the
bracket’s slotted hole.
Frame mounting (AAP models)
The AAP-mountable transmitters (MTP T SVA AAP and
MTP T AV AAP) can be mounted to any Extron AAP mounting
frame that accepts a double space (double height) AAP module.
See AAP accessories in the appendix for a partial list of AAP
devices.
The rear panel MTP connections will be inaccessible
after installation. Make all connections (see Transmitter/
receiver throughput connections, page 2-10) and test
the twisted pair system (apply a video source and observe
that transmitted video is displayed satisfactorily) before
installing the panel-mounted transmitter.
Install an MTP transmitter in an AAP frame as follows (figure 2-4):
MTP T AV AAP
AAP 102
A
A
P
1
0
2
A
U
D
IO
V
ID
E
O
LR
M
T
P
T
A
V
A
A
P
Figure 2-4 — AAP mounting an MTP transmitter
1. If necessary, remove the AAP frame from the device in
which it is installed.
2. Cable the rear of the transmitter before fastening the AAP
module to the AAP frame.
3. Insert each of the AAP module’s screws through the holes
in the AAP frame. Secure the transmitter to the frame with
the provided captive washers and #4-40 nuts.
4. Install the AAP frame as appropriate to the type of frame.
Figure 2-4 shows the transmitter module being installed in
an AAP 102 wall mounting frame and the frame being
installed in a wall box.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. [phone]
Fax [phone]
[e-mail]