im Vertrieb von CAMBOARD Electronics User’s Guide VersaTools® MTP Series Video and Audio Mini Twisted Pair Transmitters and Receivers www.extron.com Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan 1230 South Lewis Street Anaheim, CA 92805 USA 714.491.1500 Fax 714.491.1517 Beeldschermweg 6C 3821 AH Amersfoort The Netherlands +31.33.453.4040 Fax +31.33.453.4050 135 Joo Seng Road, #04-01 PM Industrial Building Singapore 368363 +65.6383.
im Vertrieb von Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product's enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
im Vertrieb von CAMBOARD Electronics Table of Contents Chapter 1 • Introduction .......................................................... 1-1 About the MTP Transmitters and Receivers ............ 1-2 TP Cable Advantages ........................................................... 1-2 Transmission Distance ......................................................... 1-2 Chapter 2 • Installation ............................................................. 2-1 Mounting Options .................................
imContents, Vertrieb von Table of cont’d CAMBOARD Electronics VersaTools® MTP Series 1 Chapter One Introduction About the MTP Transmitters and Receivers TP Cable Advantages Transmission Distance All trademarks mentioned in this manual are the properties of their respective owners. 68-732-01 Rev. E 04 05 ii www.camboard.de ® MTP Series • Table of Contents VersaTools Tel. 07131 911201 Fax 07131 911203 ce-info@camboard.
im Vertrieb von Introduction CAMBOARD Electronics About the MTP Transmitters and Receivers MTP Series Features eat pl m ed m nt 45 ou m ed nt ou Pm ) AA CA (R o di o Au di Au ive pt (ca w) re sc e sit po m eo Co vid eo Transmitters vid The MTPs are a part of the Extron VersaTools® line of basic distribution amplifiers, switchers, transmitters, receivers, and associated video accessories.
im Vertrieb von Introduction, cont’d CAMBOARD Electronics VersaTools® MTP Series 2 Chapter Two Installation Mounting Options Panel Features and Connections 1-4 www.camboard.de ® VersaTools MTP Series • Introduction Tel. 07131 911201 Fax 07131 911203 ce-info@camboard.
im Vertrieb von Installation CAUTION CAMBOARD Electronics Installation and service must be performed by authorized personnel only. Mounting Options VersaTools Rack Shelf Tabletop use (all except AAP and 45 models) The non-AAP and non-45 model MTPs come with self-adhesive rubber feet attached to the four corners of the bottom. Set the MTP on a horizontal surface.
im Vertrieb von Installation, cont’d CAMBOARD Electronics Furniture or projector mounting (all except AAP and 45 models) Frame mounting (AAP models) The AAP-mountable transmitters (MTP T SVA AAP and MTP T AV AAP) can be mounted to any Extron AAP mounting frame that accepts a double space (double height) AAP module. See AAP accessories in the appendix for a partial list of AAP devices.
im Vertrieb von Installation, cont’d CAMBOARD Electronics Panel mounting (45 models) The MTP T SVA 45 and MTP T AV 45 can be mounted to wallmountable or floor box-mountable 45 mm plates, which are commonly used in wall mount and floor box applications throughout Europe. Figure 2-5 shows one example of such an installation. The rear panel MTP connections will be inaccessible after installation.
im Vertrieb von Installation, cont’d CAMBOARD Electronics Panel Features and Connections Transmitter input connections 1 S-video connector (SV models) — Connect an S-video input to this 4-pin mini DIN connector. 2 Composite video connector (CV and AV models) — Connect a composite video input to this connector (female RCA on the MTP T AV AAP and MTP T AV 45, female BNC on all other models).
im Vertrieb von Installation, cont’d CAMBOARD Electronics CAUTION Tip (Signal) Right Channel (Red Jacket) RJ-45 termination must comply with the TIA/EIA T 568A or TIA/EIA T 568B wiring standards for all connections. Sleeve (Gnd ) 5 Left Channel (White Jacket) Figure 2-9 — RCA audio connectors See figure 2-10 to identify the connections between the transmitter and receiver. L S-VIDEO L OUTPUT 12V 0.
im Vertrieb von Installation, cont’d CAMBOARD Electronics TP cable termination Power connection (all models) and panel screws (AAP models) Figure 2-12 details the recommended termination of TP cables with RJ-45 or spring force connectors in accordance with the TIA/EIA T 568A or TIA/EIA T 568B wiring standards. You can use either standard, but ensure that you use the same standard on both cable ends. See figure 2-13 to identify the power connections and indicators and to identify the panel screws.
im Vertrieb von Installation, cont’d CAMBOARD Electronics CAUTION Power supply voltage polarity is critical. Incorrect voltage polarity can damage the power supply and the MTP. Identify the power cord negative lead by the ridges on the side of the cord (figure 2-14). CAUTION The length of the exposed (stripped) copper wires is important. The ideal length is 0.2" (5 mm). Longer bare wires can short together. Shorter wires are not as secure in the captive screw connectors and could be pulled out.
im Vertrieb von CAMBOARD Electronics VersaTools® MTP Series 3 Chapter Three Operation Front Panel Features Troubleshooting — Skew Delay Compensation 2-16 www.camboard.de Tel. 07131 911201 Fax 07131 911203 ce-info@camboard.
im Vertrieb von Operation CAMBOARD Electronics Front Panel Features 1 SHARP 2 C GAIN 3 VersaTools® MTP Series MTP R S-video Receiver Front Panel Y GAIN SHARP 1 GAIN MTP R Composite Video Receiver Front Panel 3 3 2 Figure 3-1 — MTP receiver front panels 1 Power LED — When lit, this LED indicates power is applied to the MTP. 2 Sharpness — Adjusts the output image sharpness for long cable runs. 3 Gain control — Adjusts the brightness of the output image to compensate for long cable runs.
im Vertrieb vonNumbers, and Accessories CAMBOARD Electronics Specifications, Part Specifications Nominal level ............................... 1 V p-p for Y of S-video and for composite video 0.3 V p-p for C of S-video Minimum/maximum levels ...... 0.3 V to 1.5 Vp-p Impedance .................................... 75 ohms Return loss .................................... <-35 dB @ 5 MHz DC offset ....................................... ±5 mV with input at 0 offset Video Gain .................................
im Vertrieb Specifications, Partvon Numbers, Accessories, cont’d CAMBOARD Electronics Nominal level ............................... -10 dBV (0.32 Vrms) Maximum level ............................ >+2.4 dBu (balanced or unbalanced) at 1%THD+N 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV 2 dBu. Audio output — audio models (A, AV, SVA models) only Number/signal type MTP T Series (all models) MTP R AV, MTP R SV A MTP R AV/SV A RCA .... Connectors MTP T Series .................... MTP T AAP Series ...........
im Vertrieb Specifications, Partvon Numbers, Accessories, cont’d CAMBOARD Electronics Cables/connectors Part Numbers Enhanced Skew-Free™ A/V UTP cables are not recommended for Ethernet/LAN applications.
im Vertrieb Specifications, Partvon Numbers, Accessories, cont’d CAMBOARD Electronics A-8 www.camboard.de ® VersaTools MTP Series • Reference Information Tel. 07131 911201 Fax 07131 911203 ce-info@camboard.
