Setup Guide Owner's manual

Refer also to the VersaTools
®
MTP Series User’s Manual at www.extron.com.
Receiver output connections
Figure 1‑8 shows all combinations of rear panel output
connections for the MTP receivers.
MTP R AV RCA,
Rear Panel
MTP R AV,
Rear Panel
MTP R SV A RCA,
Rear Panel
MTP R SV A,
Rear Panel
OUTPUT
MTP R AV RCA
INPUT
VIDEO
12V
0.5a MAX
LR
OUTPUT
MTP R SV A
L R
INPUT
S-VIDEO
12V
0.5a MAX
OUTPUT
MTP R SV A RCA
INPUT
S-VIDEO
12V
0.5a MAX
L
R
OUTPUT
MTP R AV
LR
INPUT
VIDEO
12V
0.5a MAX
j
j
k
k
i
h
Figure 1-8 — Output connector wiring
h
S-video connector (SV models) — Connect an S‑video device to
this 4‑pin mini DIN connector.
i
Composite video connector (CV and AV models) — Connect a
composite video device to this BNC connector.
j
Captive screw audio connector (MTP R SV A, MTP R AV)
— Connect a balanced or unbalanced audio device, such as an
audio amplier, to this 3.5 mm, 5‑pole captive screw connector.
See Figure 1‑9 to properly wire the output connector.
Unbalanced Stereo Output Balanced Stereo Output
L R
Do not tin the wires!
Ring
Sleeve(s)
Tip
Tip
Ring
Sleeve(s)
Tip
Tip
NO GROUND HERE.
NO GROUND HERE.
Figure 1-9 — Audio Output connector wiring
C
Connect the sleeve to ground (_). Connecting the sleeve
to a negative (-) terminal will damage the audio output
circuits.
k
RCA audio connectors (RCA models) — Connect a stereo audio
device to these L(eft) and R(ight) RCA connectors.
VersaTools
®
MTP Series • Installation
Installation, cont’d
1-10