User Guide Owner's manual

2-9

USB HUB4 Series • Installation

PRELIMINARY

Sleeve ( )

Ring (

)

Tip (+)

3.5 mm Stereo Plug Connector

(balanced)

6. Insert the wall box or mounting bracket into the opening, and attach it to the

wall, stud, or furniture, leaving the front edge ush with the outer wall or

furniture surface.

Installation Cable

Cable Clamp

Wall Stud

Installation Cable

Cable Clamp

Wall Stud

Screws or NailsScrews or Nails

Attaching a wall box to a wall stud

• To attach a wall box to wood, use four #8 or #10 screws or 10-penny nails.

A minimum of 1/2 inch (1.3 cm) of screw threads must penetrate the

wood.

• To attach a wall box to metal, use four #8 or #10 self-tapping sheet metal

screws or machine bolts with matching nuts.

• If using a mounting bracket, follow the directions included with the

bracket to attach the clips that fasten the bracket to the wall or furniture.

Cable and test the HUB4 before mounting it to the wall box, mounting bracket,

or furniture.

Mounting the hub to a ounting frae

If the HUB4 will be mounted to a wall box or mounting bracket, it must rst be

mounted into an AAP or MAAP mounting frame, such as the Extron AAP 102 or

CPM101. See “Optional accessories” in appendix A, “Reference Material”, for

information on ordering the mounting frames.

Follow the steps below to mount the HUB4 into the appropriate size mounting

frame.

USB HUB4 AAP:

1. Insert the four threaded studs on the back of the front panel through the

holes in an AAP mounting frame and seat the HUB4 in the frame’s two-gang

opening.

2. Attach the provided hex nuts to the studs on the back side of the frame.

See the example on the next page.