User Guide Owner's manual

Installation and Operation, cont’d
TP T Series Transmitters • Installation and Operation
2-10
PRELIMINARY
a
Audio input connector — Connect PC audio to this 3.5 mm stereo jack. Wire
the male plug as shown below.
N
Only analog line level audio signals should be input on the audio input
connector.
Sleeve ( )
Ring (R)
Tip (L)
Audio input wiring
b
Computer Input connector — Connect a computer video
source to this female 15-pin HD connector.
On the TP T 15HD A and the TP T 15HD AV, this connector
accepts computer video. It can also accommodate
component video, S-video, or composite video if the signal
is input on the R, G, and B pins of the 15HD connector using an Extron SYM
BNCF/0.5 6-inch (15 cm) cable, part #26-531-01.
Transmission of component video, S-video, or composite video on the
computer video input requires that internal jumpers be reconfigured. See
“Configuring video jumpers for component, S-video, and composite video,”
earlier in this chapter.
N
Input only sync signals, no video signals, on the sync pins (pins 13
and 14).
N
For component video, use the R (R-Y) and R return pins (pins 1 and
6), G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return
pins (pins 3 and 8).

For S-video, use the R, R return (C-chroma), G, and G return (Y-luma)
pins.

For composite video, use the G pin and the associated return pin. For
additional genlocked video signals, use the R, B, and associated return
pins into the next TP receiver.
N
Composite video, S-video, and component video signals input on the
female 15-pin HD connector are transmitted out of, or output on, the
computer video transmission RJ-45 connector(s) (
g
in the rear panel
illustrations on the previous page).
c
Buffered Local Monitor output connector — Connect a local monitor video
cable to this female 15-pin HD connector.
d
Video input connector — Connect composite video to this RCA connector.
e
Audio input connector pair — Connect left and right stereo audio to this pair
of RCA connectors.
N
Only analog line level audio signals should be input on these
connectors.
5 1
15 11
610
INPUT
COMPUTER