User`s manual

TP Receivers • Installation and Operation
2-11
5. For through-surface mounting (all except TP R 15HD A),
insert four #8 wood screws through the bracket and into
the four pilot holes. Tighten all four screws to secure the
receiver in place.
6. For under-surface mounting, insert #8 wood screws into
the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4 inch of the screw
protrudes.
7. For under-surface mounting, align the mounting screws
with the slots in the brackets and place the receiver against
the surface with the screws through the bracket slots.
8. For under-surface mounting, slide the receiver slightly
forward or back, then tighten all four screws to secure the
switcher in place.
Projector mounting
All of the receiver models can be mounted on a projector
bracket using the appropriate optional mounting bracket, the
Extron Pole Mount Kit for One quarter Rack Width Product (part
#70-217-01) (TP R 15 HD A) or Pole Mount Kit for One quarter or
half Rack Width Product (part #70-077-04) (all other models).
Secure the mounting bracket to the receiver using two machine
screws in the side of the receiver (TP R 15HD A) or the three #8
machine screws provided (all other models). Secure the
receiver to a projector mount or other surface by inserting the
mounting bolt through the bracket’s slotted hole (figure 2-6).
TP R 15HD A
C SYNC
SOG
C VIDEO
N/C
L
R
AUDIO
OUTPUT
AV INPUT
RGB
POWER
15V
.34A MAX
Mounting
Bolt
Projector
Mounting
Bracket
Figure 2-6 — Projector bracket mounting a receiver