User`s manual

TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-10
Furniture mounting
All receiver models can be mounted under furniture such
as a table or podium surface using the appropriate optional
mounting bracket; the Extron Under-Desk Mounting Kit for 1/8
and 1/4 Rack Width Products (part #70-212-01) (TP R 15 HD A)
or Under-Desk Mounting Kit for 1/2 Rack Width Products (part
#70-077-01) (all other models).
All models except the TP R 15HD A can be mounted through
a table or podium using an Extron Through-Desk Mounting
Kit for quarter or half Rack Width Products (part #70-077-02).
Furniture mount the receiver as follows:
1. Attach the mounting brackets to the receiver with the
machine screws provided (figure 2-5).
Extron
TP R BNC A
Extron
TP R BNC A
Extron
TP R 15HDA
RGB INPUT
RGB OUTPUT
R
G
B H/HV
V
A
AUDIO
L
R
B
SOG
C SYNC
POWER
15V .5A DC
L R
RGB INPUT
RGB OUTPUT
R
G
B
H/HV V
A
AUDIO
L
R
B
SOG
C SYNC
P
O
W
E
R
15V .5A DC
L R
Through-desk
Mounted
Under-desk
Mounted
Under-desk
Mounted
TP R 15HD A
RGB
PEAKING
LEVEL
Figure 2-5 — Under-desk or through-desk mounting
2. For through-surface mounting (all except TP R 15HD A),
cut the proper sized hole in the mounting surface.
3. Hold the receiver with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4. Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch
(6.3 mm) deep in the mounting surface at the marked
screw locations.