User guide
The screen may need a high level of backlighting for readability when ambient lighting is high.
With low ambient lighting, the backlighting should be low. Auto Backlight provides a suitable
amount of backlighting that is automatically calculated from the amount of ambient light
detected by the light detector.
Use the on-screen button to toggle the Auto Backlight option between
Off and On. When Auto
Backlight is set to Off, the Backlight control allows the backlighting to be set manually from 0
to 100 percent.
NOTE: When Auto Backlight is set to On, changing the percentage of Backlight will not
affect the amount of backlighting.
The PoE status (active or inactive) is shown in the top right corner.
Volume Screen
Exit
Master: 255
Click: 200
Sounds: 200
Down Up
Down Up
Down Up
Down Up
Line In: 32
Main
Volume
Time
Network
Video
Figure 12. Volume Screen
Press the Down or Up buttons to highlight one of the adjustable audio features. Use the same
buttons to adjust the following settings:
z Master volume (between 0 and 255; default 255) sets the maximum volume for
all the other sound volume settings. For example, if the master volume is set to 200
(approximately 80 percent of maximum), even when the Line In volume is set to 255
(maximum), it will only be equivalent to 80 percent of maximum.
z Click (between 0 and 255; default 200) sets the volume for audible feedback that
accompanies events such as a screen button being pressed.
z Sounds (between 0 and 255; default 200) sets the volume of audio from any audio file
playback.
z Line In (between 0 and 255; default 32) sets the volume of the audio signal received
through the line in from an Extron MTP transmitter.
TLP 710CV • Initial Conguration and Calibration 19