User guide

Installation
Overview
This section provides an overview of the main steps required to install the TLP 710CV and
provides links to more detailed explanations of each step.
You can also visit the TouchLink
touchpanel site at www.extron.com/touchlink for further assistance in the setup and
operation of the TLP 710CV, or to enroll in online training. For additional assistance,
contact your nearest Extron office.
The instructions provided in this guide are for experienced installers. To avoid damaging the
furniture, Extron recommends that the opening in the table for the TLP 710CV should be cut
only by a licensed and bonded craftsperson.
Planning
 Decide what the system requires and ensure that there is enough space for all the
components of the system.
 Collect the tools needed to complete the installation.
 Open the shipping container and verify that all the components are present.
Mounting the TLP 710CV
 Decide how to cut the hole and obtain the proper cutout dimensions or a router
template.
 Cut a hole in the furniture.
Preparing and Installing the AAP Assembly
 Run but do not connect the cables for the AAPs and TLP 710CV.
 Install cable retractors, if required.
 If required, install the power module.
 Install AAPs. Loosely fasten all AAPs to the AAP assembly and install cables.
 Install the AAP assembly into the Cable Cubby enclosure and tighten all AAPs.
 Mount and secure the TLP 710CV frame into the furniture opening.
Connecting the Touchpanel
 Connect the TLP to the PoE power supply and connect the power supply to a network
router.
NOTE: Extron recommends using the PoE power supply (provided). Alternatively, it is
possible to connect a 12 VDC power supply (not provided).
(Optional) If you are not using PoE, mount and connect a 12 VDC power supply to
the TLP 710CV and connect the TLP 710CV directly to a network router.
 (Optional) For the video monitoring capabilities, connect the MTP transmitter input.
TLP 710CV • Installation Overview 4