User guide

Initial Calibration
This section describes:
• Accessing the Internal On-screen Menus
• Main Screen
• Volume Screen
• Time Screen
• Network Screen
• Video Screen
• Touch Calibration Screen
Accessing the Internal On-screen Menus
When the TouchLink panel first has power applied, the unit boots up and displays the
opening screen. To access the on-screen menus, press the Menu button (see page 5 for
the TLP710MV or page 10 for the TLP710TV).
The menus open at the Main screen. There are five different screens (Main, Volume,
Time, Network, and Video) that can be selected by pressing the appropriate button at
the left edge of the screen.
There is also an Exit button at the bottom left corner of the screen. This button applies
and saves any changes and closes the menu screens.
Main Screen
Main
Volume
Time
Network
Video
Exit
On
On
Down Up
Sleep timer: 300 Sec
Down Up
Backlight: 073%
Auto Backlight
Wake on Motion
PoE
Active
Figure 13. Main Screen
Values can be changed by pressing the buttons to highlight them. Press the Down or Up
buttons to adjust the values or toggle the Auto Backlight or Wake on Motion buttons
between Off and On. When the function has a value (other than on or off), that value is
shown above the buttons.
TLP 710MV and TLP 710TV • Initial Calibration 14