Setup guide

8
68-2117-50 Rev. D 04 13
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX [phone] FAX
Extron Europe
+800.3987.6673
(Inside Europe Only)
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
© 2013 Extron Electronics All rights reserved. www.extron.com
8
TLP 710CV and TLE 710 • Setup Guide (Continued)
Calibration Screen
1. To access the calibration screen, press the Menu button a second time (
g
in the gures on page 6). The calibration screen
opens with the on-screen button in the top left corner highlighted.
+
+
++
Press and Hold
Highlighted Box
Until Color Changes
2. Press the highlighted button until it turns gray and a new button is highlighted. When all four points have been calibrated, the
screen reopens to the Main Screen.
3. Press Exit to close the on-screen menus.
4. Reattach the bezel.
Reset Modes
The touchpanel has four reset modes: Factory Firmware Mode, Run or Stop Events Mode, Reset All IP Settings Mode, and Reset
Factory Defaults Mode. These modes can be initiated by pressing the reset button (
f
in the gures on page 6). Do not use the
reset button until you have read all the information about the different modes (see the TLP710CV User Guide).
GUI Design and Conguration
Use Extron GUI Congurator (version 1.3 or later) to design the graphical user interface that will appear on the TouchLink panel.
Use Extron Global Congurator (version 3.3 or later) to assign functions to the elements of the graphical user interface. For
complete information about these software programs, see the help le of the appropriate program.