User guide

LAN Connector

MTP Connector

Zip-tie Holder

Cable Runway

Figure 11. Connecting and Securing Cables

Power connector — connect the two pole, 3.5 mm captive screw connector from

the 12 VDC, 1.0 A power supply (not provided) to the power supply socket on the

rear panel. Ensure the connections have the correct polarity as shown below.

NOTES: • Extron recommends using the Power over Ethernet power supply.

The 12 VDC, 1.0 A power supply should be used only for setup or

troubleshooting.

• If both power supplies are connected to the TLP 1000TV, the PoE power

supply takes precedence.

Power Receptacle

DC Power Cord

Captive Screw Connector

AC Power Cord

Ground

+12 VDC

External

Power Supply

(12 VDC, 1 A )

SECTION A–A

Ridges

Smooth

Power Supply

Output Cord

3/16"

(5 mm) Max.

Figure 12. Power Supply Connection

CAUTION: See the cautions on page 8 for important information about power

supplies.

NOTE: See the notes on page 8 for important information about wiring captive

screw connectors.

TLP 1000MV and TLP 1000TV • Panel Features 12