User Guide Manual

SIS
™
Programming and Control, cont’d
System 5 IP • SIS
™
Programming and Control5-30
PRELIMINARY
Command/response table for SIS commands (continued) Command ASCII (Telnet) URL Encoded (Web) Response Additional description
(host to switcher) (host to switcher) (switcher to host)
Set button lamps to blink slowly
24
Esc
1*
X212
LX W1%2A
X212
LX
|
Lbk*1*
X212
X212
= Status (in hexadecimal characters) of
control of lamp enabling (control of button lights). This variable is 00000### where # represents a hexadecimal character calculated from a binary bit map. See page 5-29 for details.
View which button lamps are set to blink slowly
Esc
1 LX W1LX
|
X212
Set button lamps to blink quickly
24
Esc
2*
X212
LX W2%2A
X212
LX
|
Lbk*2*
X212
View which button lamps are set to blink quickly
Esc
2 LX W2LX
|
X212
The command to set a button to blink quickly takes precedence over the command to make it blink slowly. If a button lamp is set to blink both quickly and slowly, the button blinks quickly.
Reset (zap) commands and erase commands
Erase user-supplied Web page & files
24, 28
Esc
filename EF Wfilename EF
|
Del • filename
Erase current directory and its files
24, 28
Esc
/EF W%2F EF
|
Ddl
Erase current directory & its subdirectories
24, 28
Esc
//EF W%2F%2F EF
|
Ddl
Erase the flash memory
24
Esc
ZFFF WZFFF
|
Zpf
Reset all device settings to factory default
24
Esc
ZXXX WZXXX
|
Zpx
The ZXXX command does not reset any IP-related settings or user-defined flash memory contents.
Reset all device settings
and delete files
Esc
ZY WZY
|
Zpy
In order to preserve communication with the device, the ZY command does not reset any IP-related settings , the unit name, DHCP settings, or port mapping settings.
Extron recommends performing a ZY reset after you upgrade the firmware.
Absolute system reset
24
Esc
ZQQQ WZQQQ
|
Zpq Reset all settings/memories. The ZQQQ
command resets everything (all settings, adjustments, the IP address, and subnet mask, PINs) to the factory default values, and it erases flash memory.The IP address is reset to 192.168.254.254, the subnet mask is reset to 255.255.0.0. This command is identical to reset mode 5, discussed in “Resetting the unit” in chapter two.
Event control