User Guide Manual

5-25System 5 IP • SIS
™
Programming and Control
PRELIMINARY
Command/response table for SIS commands (continued) Command ASCII (Telnet) URL Encoded (Web) Response Additional description
(host to switcher) (host to switcher) (switcher to host)
E-mail
Configure e-mail events
24
Esc
X45
,
X46
,
X47
CR
W
X45
%2C
X46
%2C
X47
CR
|
Ipr
X45
,
X46
,
X47
X45
= e-mail event number (1 - 64). The
response is 2 digits with leading zeros.
X46
= e-mail recipient’s address (e.g.,
[e-mail]) for the person to whom messages will be sent.
X47
= name of e-mail file to be sent
(first line of the file = the subject, the rest = the body of the e-mail). For the CR command,
X47
= filename of the e-mail
file to be sent, e.g. 1.eml, 2.eml, ... 64.eml
The filename must be x.eml where x is a number from 1-999. The first line of the e-mail file = the subject. The rest = the body of the e-mail.
Example:
Esc
5, [e-mail], 7.eml CR
W 5%2Cjdoe%40extron%2Ecom%2C 7%2Eeml CR
|
Ipr 5, [e-mail], 7.eml For e-mail event 5, send file 7.eml to
[e-mail].
Read e-mail events
Esc
X45
CR W
X45
CR
|
X46
,
X47
Send e-mail (event)
24
Esc
X45
SM W
X45
SM
|
Eml
X45
For the SM commands,
X47
= number
(numeral) of the e-mail file. The SM command overrides the e-mail file set by the CR command (above). If
X47
= 0 or is
missing (the number is not specified or the file is not available), the file designated (set) in the CR command is sent instead.
Send e-mail (event) using a different file
24
Esc
X45
,
X70
,
X47
SM W
X45
%2C
X70
%2C
X47
SM
|
Eml
X45
X70
= a number that is an optional
parameter to insert into the e-mail if the email file contains an embedded server-side include, “<!--#echo var = WCR
|
” -->”,
which is the
Esc
CR command without
any parameters. Use 0 as a placeholder if the optional
X47
is used but
X70
isn’t
needed.
Set e-mail server IP address and user domain name
24
Esc
X14
,
X15
CM W
X14
%2C
X15
CM
|
Ipm•
X14
,
X15
X14
= IP address (xxx.xxx.xxx.xxx). Leading
zeros are optional in setting values.
X15
= E-mail domain name, e.g., extron.com