User Guide Manual

SIS
™
Programming and Control, cont’d
System 5 IP • SIS
™
Programming and Control5-22
PRELIMINARY
Command/response table for SIS commands (continued) Command ASCII (Telnet) URL Encoded (Web) Response Additional description
(host to switcher) (host to switcher) (switcher to host)
Passwords and security settings
Set administrator password
24
Esc
X33
CA W
X33
CA
|
Ipa•
X41
Set the administrator access password (
X33
).
The password is case sensitive. Special characters (spaces, symbols) are not allowed.
X33
= password (4-12 characters,
no special characters are allowed)
X41
= reading password. If the switcher is
connected via RS-232, the response is a password. If the switcher is connected via IP, it responds with 4 asterisks (****) if a password exists or with nothing (empty/ blank) if no password has been set.
Clear administrator password
24
Esc
•CA W%20CA
|
Ipa• Clear/remove all passwords (administrator
and user).
A user password cannot be assigned if an administrator password does not exist. Entering a password when the System 5 IP has not been configured for one will yield an E14 response from the switcher. If the administrator password is cleared (removed), the user password is automatically removed.
Read administrator password
24
Esc
CA WCA
|
X41
Set user password
24
Esc
X33
CU W
X33
CU
|
Ipu•
X41
Set the user password (
X33
is 4 to 12
alphanumeric characters). The password is case sensitive. Special characters (spaces, symbols) are not allowed.
A user password cannot be assigned if an administrator password does not exist.
Clear user password
24
Esc
•CU W%20CU
|
Ipu• This clears the user password only.
Read/view user password
24
Esc
CU WCU
|
X41
Read connection’s security level
Esc
CK WCK
|
X52
For
X52
: connection’s security level. If used
as a response, this is returned as 2 digits with a leading zero. 0 = anonymous 1-10 = extended security levels 1 through 10 11 = user 12 = administrator