Setup Guide User Manual

i
System 5 IP Switchers • Table of Contents
Table of Contents
Chapter One • Introduction ................................................... 1-1
About this Manual .................................................................... 1-2
About the System 5 IP Series Switchers ............................ 1-2
About Global Configurator .................................................... 1-3
System Requirements ............................................................... 1-4
Installing the Software ............................................................ 1-4
Updating Firmware ................................................................... 1-5
Chapter Two • System 5 IP Hardware Setup ............... 2-1
Rear Panels and Cabling .......................................................... 2-2
A/V input and video output connections ............................. 2-2
Audio output connections ..................................................... 2-3
Control connections ............................................................... 2-5
Front Panel Features and Basic Operation ...................... 2-10
Control ports ........................................................................ 2-11
Buttons
................................................................................. 2-11
Indicators .............................................................................. 2-13
Chapter Three • System 5 IP Software Setup ............ 3-1
Online Training ........................................................................... 3-3
Step 1: Download Device Drivers ....................................... 3-3
Step 2: Create a New Project ............................................... 3-4
Step 3: Add a System 5 IP Switcher and Define its
Location ........................................................................................ 3-6
Step 4: Define E-mail Settings ............................................ 3-8
Defining e-mail server settings
............................................. 3-8
Setting up e-mail notifications
............................................. 3-9
Adding e-mail contacts
........................................................ 3-11
Step 5: Add a Serial and an IR Device .............................. 3-12
Downloading additional drivers
......................................... 3-12
Adding a serial driver
......................................................... 3-12
Adding an IR driver
.............................................................. 3-13
Step 6: Configure the Front Panel Buttons .................... 3-14
Configuring an input button
............................................... 3-15
Configuring the On and Off buttons
.................................. 3-16
Step 7: Configure the Control Modules Using the
Auto Fill Feature ....................................................................... 3-17