User’s Manual SW2 VGA DA2 A, SW2 VGA DA2 AF www.extron.com Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan 1230 South Lewis Street Anaheim, CA 92805 USA 714.491.1500 Fax 714.491.1517 Beeldschermweg 6C 3821 AH Amersfoort The Netherlands +31.33.453.4040 Fax +31.33.453.4050 135 Joo Seng Road, #04-01 PM Industrial Building Singapore 368363 +65.6383.4400 Fax +65.6383.4664 Kyodo Building 16 Ichibancho Chiyoda-ku, Tokyo 102-0082 Japan +81.3.3511.
Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product's enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
Table of Contents Chapter 1 • Introduction .......................................................... 1-1 About this Manual ................................................................ 1-2 About the SW2 VGA DA2 A /AF ...................................... 1-2 Features ...................................................................................... 1-2 Chapter 2 • Installation and Operation .......................... 2-1 Installation Overview .......................................................
Table of Contents, cont’d SW2 VGA DA2 A /AF 1 Chapter One Introduction About this Manual About the SW2 VGA DA2 A /AF Features ii SW2 VGA DA2 A /AF • Table of Contents
Introduction, cont’d Introduction About this Manual This manual contains information about the Extron SW2 VGA DA2 A and SW2 VGA DA2 AF switchers and details on how to operate and configure them. SW2 VGA DA2 A /AF About the SW2 VGA DA2 A /AF The SW2 VGA DA2 A /AF is a high performance, two-input computer-video switcher with 300 MHz (-3 dB) video bandwidth. It accepts two VGA-UXGA computer-video inputs and two stereo audio inputs. It features two buffered VGAUXGA outputs and one stereo audio output.
Installation and Operation, cont’d Installation and Operation diagonally opposite corners, as shown in the following illustration. Installation Overview To install and set up the SW2 VGA DA2 A /AF for operation, follow these steps: 1 Turn all of the equipment off.
Installation and Operation, cont’d EXT SW 12 ITCH V 0.5A MA X IN P 1 U TS 2 A (L O OU CA LM O N IT OR TP U TS ) B L R SW 2 VG AS 1 A DA /REM 2 I OT A 2 AF E SW AUTO ITC H S Under-desk mounting Through-desk mounting 2-4 1. Hold the front panel of the switcher against the desk or table. Use a soft pencil to mark the rough-in opening on the desk. The opening, approximately 8.88" x 1.13" (22.5 cm x 2.9 cm) will be slightly larger than the switcher enclosure. 2.
Installation and Operation, cont’d Front Panel Features Rear Panel Features SW2 VGA DA2 A POWER AUTO SWITCH 1 2 3 4 5 6 7 1 INPUT AUTO SWITCH 1 POWER 12V 0.2A MAX 2 2 SW2 VGA DA2 AF SW2 VGA DA2 A OUTPUTS CONTACT AUTO-SW 2 1 SW2 VGA DA2 A 1 INPUT 12V 0.
Installation and Operation, cont’d Connect the sleeve to ground (GND). Connecting the sleeve to a negative (-) terminal will damage the audio output circuits. Unbalanced Output Tip See Warning Sleeve (s) Tip See Warning Cabling Attach cables to the switcher as detailed in the steps below. The diagram in this section shows how the system looks when cabling is finished. 1. Attach the computers’ video output cables to the switcher via the 15-pin HD female input connectors.
Installation and Operation, cont’d Extron SW2 VGA DA2 A EX Switcher T SW 12V ITCH 0.5A MA X Laptop IN P 1 U TS Troubleshooting If the image does not appear or there is no sound 1. Ensure that all devices are plugged in to a power source. 2. Make sure that each device is receiving power. If the switcher is in manual switch mode, one of the input indicator LEDs should light on the front panel of the SW2 VGA DA2 A /AF.
Installation and Operation, cont’d SW2 VGA DA2 A /AF A Appendix Specifications, Accessories and Part Numbers Specifications Included Parts Accessories Cables Adapters 2-12 SW2 VGA DA2 A /AF • Installation and Operation
Specifications, cont’d Specifications Video Gain ................................................ Unity Bandwidth ..................................... 300 MHz (-3 dB) Video input Number/signal type ................... 2 VGA-UXGA RGBHV, RGBS, RGsB*, RsGsBs* Connectors ................................... 2 VGA female 15-pin HD Nominal level ............................... 0.7 Vp-p for RGB Minimum/maximum levels ............ Analog: 0.3 V to 1.5 Vp-p with no offset Impedance ................................
Accessories and Part Numbers, cont’d Temperature/humidity .............. Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing Rack mount SW2 VGA DA2 A /AF ................ Yes, with optional 1U rack shelf, part #60-190-01 or 60-604-01; or 6" deep rack shelf, part #60-190-10 or 60-604-10 ; or VersaTools® rack shelf, part #60-190-20 or 60-604-20.
Accessories and Part Numbers, cont’d Cables, continued Male-to-female VGA with audio cables Part number VGA 3’ MHRA 26-491-01 VGA 6’ MHRA 26-491-02 VGA 12’ MHRA 26-491-03 VGA 25’ MHRA 26-491-04 VGA 50’ MHRA 26-491-08 Adapters Adapters A-6 Part number Mac/VGA adapter 26-340-01 Mac HV/VGA adapter 26-340-02 SY-VGA/XGA-6’ (15-pin HD VGA male to 5 BNC male) 26-173-01 SW2 VGA DA2 A /AF • Accessories and Part Numbers SW2 VGA DA2 A /AF • Accessories and Part Numbers A-7
Accessories and Part Numbers, cont’d A-8 SW2 VGA DA2 A /AF • Accessories and Part Numbers
