User guide

SW HDMI Series • Remote Communication and Control 23
Symbol Definitions
]
= CR/LF (carriage return with line feed) (hex 0D 0A)
}
or
|
= Soft carriage return (no line feed)
•
= Space
E
or W = Escape
X!
= Input number
0 through the maximum number of inputs on the unit
0 = Deselect (mute) all inputs
X@
= On and Off, or mute status
0 = Off or unmuted
1 = On or muted
X#
= Video color bit depth mode
0 = Automatically truncate based on output
1 = Force truncation to 8-bit
X$
= EDID mode and file selection
1-48 = Factory-supplied EDID number (for a list of available EDID files, see the
EDID table on page 19).
49 = Automatic mode (default). The EDID of the connected display is detected and
passed to the inputs.
50-53 = User-assigned EDID
X%
= Current EDID information in hexadecimal format (128 or 256 bytes of hex data)
X^
= Native resolution and refresh rate (translated from hexadecimal)
X&
= Firmware version (to the second decimal place)
X*
= Front panel lockout enabled or disabled
0 = Front panel unlocked
1 = Front panel locked
X(
= HDCP authentication
0 = HDCP not authenticated
1 = HDCP authenticated
X1)
= Signal status
0 = No signal detected
1 = Signal detected
X1!
= On and off or enabled and disabled status
0 = Off or disabled
1 = On or enabled
X1@
= Switch mode
1 = Normal (manual)
2 = Auto-input
X1#
= Unit name. The name can have up to 24 alphanumeric characters including hyphens (-),
with no spaces. The first character must be a letter, and the last character cannot be a
hyphen. The default is SW-HDMI-SERIES.
NOTE: Unless otherwise indicated, commands are not case-sensitive.