User guide

SW HDMI Series • Operation 16
Other ways to select an input include using SIS commands (see the Input Selection
command on page 24) and optional IR remote control (see “Using the Optional IR 102
Remote Control”).
Resetting
To reset the switcher to its factory default settings:
1. Press and hold the Input 1 button while power is being applied to the unit.
2. Continue holding the Input 1 button until the power-up sequence completes.
Using the Optional IR 102 Remote Control
The optional hand-held IR 102 Remote Control lets you remotely perform functions that
are also available through the front panel buttons and SIS commands.
The IR receiver port on the front panel is located to the right of the Auto Switch LED. It
receives signals from the remote control if they are sent from within a 40-degree arc to
the right or left of the IR receiver sensor, and from no more than 30 feet (9 m) away (see
figure 17).
SW HDMI Series Switcher
IR 102 Remote Control
SW4 HDMI
HDMI SWITCHER
1
IR
CONFIG
SIGNAL
INPUTS
INPUTS
OUTPUT
1 2 3 4
HDCP
2 3 4
AUTO
SWITCH
40 40
30’
Maximum
Channel
IR 102
0
1 2 3
4
5
6
7
8
9
+10
Universal Remote
Figure 17. Area for Remote Signal Reception
Remote control buttons
On the IR 102 remote control, buttons 1 through 8
(depending on your model) select inputs. Button 0 mutes
(deselects) all inputs.
a Input Selection buttons — Press one of these
buttons to select an input.
b Input mute button (0) — Press this button to
deselect all inputs, effectively muting the output.
Universal Remote
INPUT/OUTPUT SELECTION
1234
5678
90
+10
IR 102
1
2