User`s manual

SW Switchers • Installation

Installation, cont’d

SW Switchers

Chapter Three

SW AR

xixi

xi and SW AR HV

xixi

Operation

Operating Modes

Remote Operation

2-18

Troubleshooting

The sections below shows some common operating

problems and their solutions.

All models

Problem — Pressing an input selection button does not

change the input.

Solution — Verify the operating mode. The input

selection buttons do not change the input if the

switcher is in auto-switch mode or (for

SW AR MX, SW AR MX HV, and

SW 6 Component switchers only) auto-sequence

mode.

Problem — Auto-switch does not work under composite

video, S-video, component video, or RGsB format.

Solution — The sync portion of these video formats

must be connected to a video input and to the

H/S input through a T connector. See page 2-10.

SW AR MX, SW AR MX HV, and

SW 6 Component models

Problem — You pressed input selection button 1, but the

input did not change, and one of the input/mode

selection LEDs is blinking (SW AR MX,

SW AR MX HV, and SW 6 Component switchers

only).

Solution — Holding input selection button 1 for too

long causes the button to act as the front panel

mode selection button. To select an input, do not

hold the button after pressing it.

Problem — The switcher is plugged into a functioning

power source, but does not turn on.

Solution — Replace the fuse. See page 4-11.