User Guide Manual

SMX System MultiMatrix Switcher • SMX Control Software 66
• Audio-Input Gain settings — Select this to change
the audio gain (0.5 dB steps) for all or single inputs.
To change the gain, pick an input (or All) and use the
adjustment arrows to raise or lower the gain.
NOTE: Click on the applicable Changes radio
buttons to have any changes either immediate
or verifiable.
Verify (default setting) accepts changes after
the Take button is pressed.
Immediate accepts changes instantly. The
Take button is removed.
• Click Take (if visible) to accept the changes.
• Click Use Defaults to set the selected input to the default setting.
• Click Cancel Change to return the gain to the previous setting.
• Audio-Output Volume settings — Select this option to change the audio volume
(in 1% steps) for all or single outputs.
To change the volume, pick an output (or All) and raise or
lower the volume slider.
NOTE: When an RGB input is connected, this menu
also shows the RGB delay settings (see RGB Delay
settings on page 65).
Click Close to exit the window.
To mute video or audio output, select either check box in the Mute box per selected
output number (or All).
• Mute-Output settings — Select this option to mute any or
all video or audio outputs.
To mute a video or audio signal, select an output (or All)
and check the video or audio mute box. The output is now
muted, and the output box in the main window indicates the
mute status.
Click Close to exit the window.
NOTE: When an RGB input is connected, this menu also shows the RGB delay
settings (see RGB Delay settings on page 65).
• HD-SDI Re-clocker Rate settings — Select this
option to reset the reclocking rate for HD-SDI inputs.
The Re-clocker rate sets the outputs in sync with input
signals.
If an audio board is set to the plane address, a slider will
become available for volume adjustment in this dialog
box.