User Guide Manual

SMX System MultiMatrix Switcher • SIS Configuration and Control 42
Command and Response Table for SIS Commands
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Output Switching by Plane
NOTES:
• The & tie command for RGBHV and the % tie command for video can be used interchangeably.
• The ! tie command can be used for switching both video signals and audio signals with the same plane address.
• The & tie command for RGB and the % tie command for video can be used interchangeably.
• The & read tie command for RGB and the % read tie command for video can be used interchangeably.
• Commands can be entered back-to-back in a string with no spaces.
For example: 1*1*1&001*002&001*003*003&001...
The SMX supports 1-, 2-, and 3-digit numeric entries (1*1!, 01*02*02&, or 001*003*003%).
Tie input to an output
(RGBHV)
X2@*X@*X#&
X2@OutX#
•
InX@
•
RGB]
Tie input X@ to output X# on plane
X2@ for RGB signals.
Tie input to an output (Video)
X2@*X@*X#%
X2@OutX#
•
InX@
•
Vid]
Tie input X@ to output X# on plane X2@
for Video signals.
Tie input to an output (Audio)
X2@*X@*X#$ X2@ OutX#
•
InX@
•
Aud] Tie input X@ to output X# on plane X2@
for audio signals.
Tie input to an output (All)
X2@*X@*X#! X2@OutX#
•
InX@
•
All] Tie input X@ to output X# on plane X2@
for all signals.
Tie input to all outputs
(RGBHV)
X2@*X@*& X2@InX@
•
RGB] Tie input X@ to all outputs on plane
X2@ for RGB signals.
Tie input to all outputs (video)
X2@*X@*% X2@InX@
•
Vid] Tie input X@ to all outputs on plane
X2@ for video signals.
Tie input to all outputs (audio)
X2@*X@*$ X2@InX@
•
Aud] Tie input X@ to all outputs on plane
X2@ for audio signals.
Tie input to all outputs
(audio and video)
X2@*X@*! X2@InX@
•
All] Tie input X@ to all outputs on plane
X2@ all signals.
Quick Multiple Tie
Make multiple ties
E+QX2@*X@*X#!
...X2@*X@*X#$}
Qik]
Make multiple ties with one command
entry.
Example:
E+Q01*3*4!01*3...
*5%01*3*6$
}
Qik]
Tie plane 01 input 3 audio and video
signals to outputs 4 (audio and video),
5 (video only), and 6 (audio only).
NOTE: This command activates all I/O switches simultaneously.
NOTES:
X@ = Input number 01 - <maximum number of inputs>
00 = untied
X# = Output number 01 - <maximum number of outputs>
X2@ = Plane number 00 - 15 = plane address
90 - 99 = virtual plane