User Guide User Manual

VersaTools
®
SEQ 100 Skew Equalizer
VersaTools
®
SEQ 100 Skew Equalizer, cont’d
8
VersaTools
®
SEQ 100 Skew Equalizer
9
Furniture mounting
Furniture mount the SEQ using the optional MBU 123
VersaTools under desk mounting kit, part #70-212-01 (figure 6),
as follows:
Figure 6 — Desk mounting the SEQ
1. Remove feet from the bottom of the SEQ if installed.
2. Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3. Attach one bracket to the side of the unit using the longer
screws included in the kit.
4. Repeat steps 2 and 3 on the other side of the unit.
5. Hold the SEQ with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
6. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
7. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw protrudes.
8. Align the mounting screws with the slots in the brackets
and place the SEQ against the surface, with the screws
through the bracket slots.
9. Slide the SEQ slightly forward or back, then tighten all
four screws to secure the SEQ in place.
Projector mounting
The SEQ can be mounted on a projector bracket using either of
the following optional Extron projector mounting kits:
• PMK 100 projector mounting kit (part #70-217-01)
• PMK 300 projector mounting kit (part #70-374-01)
• PMK 350 low profile projector mounting kit
(part #70-563-02 [black] or part #70-563-03 [white])
PMK 100 mounting
Projector mount the SEQ using an optional PMK 100 bracket
(figure 7) as follows:
Ceiling
Digital Projector
Projector
Mounting
Bracket
Mounting
Bolt
Projector Mounting
Figure 7 — Desk and projector mounting the SEQ
1. Remove feet from the bottom of the SEQ if installed.
2. Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3. Attach one bracket to the side of the unit using the longer
screws included in the kit.
4. Secure the SEQ to a projector mount or other surface by
inserting the mounting bolt through the bracket’s slotted
hole.