User Guide User Manual

VersaTools
®
SEQ 100 Skew Equalizer
VersaTools
®
SEQ 100 Skew Equalizer, cont’d
12
VersaTools
®
SEQ 100 Skew Equalizer
13
PMK 350 mounting
Mount the SEQ to a PMK 350 bracket (figure 10) as follows:
Extron
PMK 350
Multi-product Projector
Mounting Kit
Cover Sheet
Front Plate
Rear Plate
U-bolt
L-shaped
Bracket
Contoured
Base
Extron
Power Supply
Extron
Quarter-rack
Sized Product
Figure 10 — PMK 350 projector mounting a SEQ
1. Remove the front and back plates from the PMK 350
(figure 10), using an Extron Tweeker or a #2 Philips
screwdriver. Retain the screws to reattach the plates when
you are finished.
2. Remove feet from the bottom of the SEQ if installed.
3. Secure the SEQ to one side of the mounting tray, using two
of the supplied 4-40 x 3/16" screws in opposite (diagonal)
corners.
4. Use the two included tie wraps to strap the power supply
to the bracket.
5. Place the PMK 350 around the projector ceiling mounting
pole (figure 10).
6. Assemble the U-bolt and the following parts in the
following order (figure 11):
a. Pass the legs of the U-bolt through the slotted holes on
the mount plate flange.
b. Place the legs around the projector pole.
c. Pass the legs through the holes in the contour base.
N
The pole fits snugly into the depression in the
center of the contoured base.
d. Pass the legs through the holes in the L-shaped bracket.
N
The supplied U-bolt fits a typical (1.5" to 2.0"
diameter) ceiling pole.
U-bolt
Slotted Hole
in PMK Tray
L-shaped
Bracket
L-shaped
Bracket Screws
Contoured
Base
Ceiling
Pole
Mount Plate
Flange
Figure 11 — Hanging the tray on the pole
7. Align the two slotted holes in the bottom of the L-shaped
bracket with the two slotted holes in the base of the tray.
Secure the L-bracket to the base by inserting two provided
6-32 x 5/16" screws through the aligned slots.
8. Move the PMK 350 up to the desired location on the ceiling
pole, as close to the ceiling as desired.
9. Secure the L-shaped bracket to the U-bolt using the
included hex nuts, washers, and lock washers. Tighten the
hex nuts securely.
N
Be sure to tighten the hex nuts securely enough that the
PMK 350 does not slide down the ceiling pole. A socket
wrench is recommended to tighten the hex nuts.
10. Secure the front panel to the mounting tray with four of
the included #6 screws.
11. If desired, choose one of the provided four sizes of self-
adhesive cover sheets, and apply it to the underside of the
mounting tray.