User Guide Owner manual

Installation, Connection, and Settings, cont’d

SCS 300 • Installation, Connection, and Settings

2-8

Insert the wired connector into the female, 2-pole captive screw

connector (

)

marked "power".

C When using a compatible power source from the

projector, verify that it is 12 VDC positive.

Input connectors — Non-interlaced video signal input is made

on these ﬁve female BNC connectors, labeled Input. Connect

the input devices' video signal cables to the BNC connectors,

ensuring the correct cable matches the labeled input connector.

RGBHV – If all cables are connected, the sync input is separate

horizontal and vertical.

RGBS – If the H/HV (composite sync) cable is connected, the

input is composite sync.

RGsB, RsGsBs – If coax cables are connected and terminated

(75 ohms) to the red, green, and blue channels only, the

input is sync on green.

Output connectors — The converted video signal output is

carried on these ﬁve female BNC connectors, labelled Output.

Use BNC cables to attach the output connectors to a projector or

other display device. This output is simultaneous and identical

to the output on the 15-pin HD connector on the front panel.

RGsB — When the DIP switch (SOG Out) is set to On, and

terminated (75 ohms) coax cables are connected to red,

green, and blue channels only, the output is sync on green.

RsGsBs — When the DIP switch (RsGsBs Out) is set to On, and

terminated (75 ohms) coax cables are connected to red,

green, and blue channels only, the output is sync on all.

RGBS — When the DIP switch (Comp sync out) is set to On,

and the H/HV cable is connected, the output is composite

sync.

RGBHV — When DIP switches 3, 4, and 5 are set to Off, and all

cables are connected, the sync output is separate horizontal

and vertical.

RGsB/RsGsBs

RGBS

H/HV

RGBHV

H/HV