User’s Manual RGB 460xi , 460xi Dual, 464xi , 468xi , and 468 Mxi www.extron.com Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan 1230 South Lewis Street Anaheim, CA 92805 USA 714.491.1500 Fax 714.491.1517 Beeldschermweg 6C 3821 AH Amersfoort The Netherlands +31.33.453.4040 Fax +31.33.453.4050 135 Joo Seng Road, #04-01 PM Industrial Building Singapore 368363 +65.6383.4400 Fax +65.6383.
Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product's enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
Table of Contents Chapter 1 • Introduction .......................................................... 1-1 About this Manual ................................................................ 1-2 xi Series of Interfaces .................. 1-2 About the RGB 460xi Features ...................................................................................... 1-2 Chapter 2 • Installation and Operation ........................ 2-1 Installation Overview ..........................................................
Table of Contents, cont’d RGB 460xi xi Series 1 Chapter One Introduction About this Manual About the RGB 460xi Series of Interfaces Features ii xi Series • Table of Contents RGB 460xi
Introduction About this Manual This manual contains information about the Extron RGB 460xi series of universal wall, furniture, and floorbox mountable interfaces, and on how to configure and operate them. “RGB 460xi” or “interface” will be used to refer to all models interchangeably unless otherwise noted. For information on installing the wallbox-mountable versions of these interfaces, refer to one of the available installation guides.
Installation and Operation Installation Overview CAUTION Interface Details Installation and service must be performed by authorized personnel only. UL Listed electrical boxes are recommended. See “UL Requirements” in this chapter. Front panel features and cabling 6 RGB 460xi To install and set up an RGB 460xi series interface, follow these steps: 1 Turn all of the equipment off.
Installation and Operation, cont’d 1 Faceplate screws — These screws secure the faceplate to the rest of the interface. 8 Min/Max LED — This LED blinks red momentarily whenever the minimum or maximum limits of the horizontal shift control ( 7 ) have been reached. Continually turning the horizontal shift control knob in the same direction after the limit has been reached will cause the LED to continually blink.
Installation and Operation, cont’d Blank plates (two single-space and one double-space) are included with the interfaces to cover unused spaces. Adapter plates must be ordered separately (see “Optional Adapter Plates” in appendix A). They must also be attached to the faceplate and cabled before the interface is installed in the wall or furniture. The screws needed for installing the adapter plates are supplied (MAAPs), or built into the plates (AAPs), so no additional screws will be needed. 1.
Installation and Operation, cont’d 5 — Vertical sync pulse width — For some digital display devices, if no picture appears, the picture cuts in and out, or it is scrambled, try adjusting the output vertical sync pulse width or switching from ADSP to DDSP. If the signal cable between the interface and the output device is shorter than approximately 125 feet, and the gain switch is set to Medium or Maximum, the image may be overcompensated.
Installation and Operation, cont’d If the LED does not light, check the wiring at both the interface and the power supply, and ensure that the power supply is connected to a power source. If the input signal has sync on green, the LED will not change from yellow to green. If the image does not appear or there is no sound 1. Make sure that all the devices are powered on. 2. Ensure that the connectors are wired correctly at both ends of the cables.
Installation and Operation, cont’d Application Examples RGB 460xi xi Series Projector Modular Connector Plates H. IFT SH R NITO MO TM AX MIN/M T INPU MO NO Installation Cable NIT MO RG B 46 8 TH WI SP AD OR NIT OR DIO AU Extron RGB 468xi SVGA Compatible Computer w/ Audio Projector Installation Cable A Appendix A Specifications, Part Numbers, and Accessories Specifications H.
Specifications, Accessories, Part Numbers These specifications apply to all models unless otherwise noted. Specifications Video Gain ............................................... Unity (0.7V), 15% with 3dB peaking (0.8V), 30% with 6dB peaking (0.9V) Bandwidth .................................... 300 MHz (-3dB) Video input and loop through Number/signal type RGB 460xi Dual ................. 2 analog RGBHV, RGBS, RGsB All other models ..............
Specifications, Accessories, Part Numbers, cont’d Connectors RGB 460xi Dual ................. (2) 3.5 mm stereo female jacks (2 channel), unbalanced; tip (L), ring (R), sleeve (ground) All other models .............. 3.5 mm stereo female jack (2 channel), unbalanced; tip (L), ring (R), sleeve (ground) Impedance .................................... >5 kohms unbalanced, DC coupled Nominal level ............................... -10dBV (316mV) Maximum level ............................ +8.
Specifications, Accessories, Part Numbers, cont’d RGB 460xi SC-AFM4, RGB 464xi SC-AFM6, RGB 468xi SC-AFM6 ........ 0.8 lbs (0.4 kg) SC-AFM8 ........................... 0.6 lbs (0.3 kg) RGB 460xi, MK and FSR .. 0.5 lbs (0.2 kg) RGB 464xi, RGB 468xi, RGB 468 Mxi 0.7 lbs (0.3 kg) EC models ......................... 0.7 lbs (0.3 kg) RGB 460xi Dual ................. 1.0 lbs (0.5 kg) Shipping weight (all models) .. 3 lbs (1.4 kg) Vibration .......................................
Specifications, Accessories, Part Numbers, cont’d High-resolution cables (cont’d) Part number BNC-5-6’HRP (plenum) 26-378-02 BNC-5-12’HRP (plenum) 26-378-03 BNC-5-25’HRP (plenum) 26-378-04 BNC-5-50’HRP (plenum) 26-378-05 BNC-5-75’HRP (plenum) 26-378-06 BNC-5-100’HRP (plenum) 26-378-07 Bulk installation cable (14-conductor, non-plenum), 500’ HR 22-120-02 Bulk installation cable (17-conductor, plenum), 500’ HR 22-111-03 Optional Adapter Plates A variety of optional adapter plates for pass-th
