User Guide Manual

If the Interface Does Not Record EDID

1. Make sure you have a display device connected to the local output.

2. Make sure the rotary switch is set to 0.

3. Make sure the LED ﬂashes red slowly three times while the EDID information is stored

and returns to a solid green when the recording is completed.

4. Check Record EDID Information on page 12 and Using User-Recorded EDID

Information on page 14.

NOTE: EDID information must be available to the source device as it boots up. If you

make changes to the EDID source by adjusting the rotary dial or the frequency

DIP switch, you must reboot the source device.

If the Source Does Not Output the Correct Rate

NOTE: The resolution provided by the EDID source must be less than or equal to the

resolution of the output device.

1. Make sure you have the correct resolution and frequency selected on the rotary dial and

the DIP switch. After they have been reset, restart the source device.

2. If you are using a user-recorded EDID, make sure the rotary switch is set to 0 and make

sure valid EDID information has been saved to position 0 (see Using User-recorded

EDID Information on page 14).

3. If you are passing through EDID from a display connected to the local monitor output,

make sure the rotary dial is set to position F and make sure the display is properly

connected to the output connection.

RGB 203 Rxi • Operation 19