Instruction manual

Encore Presentation System • User’s Guide 61
3. Hardware Installation
Installation
13. Tally Connection — the Controller provides one 25-pin D connector for issuing
tally “relay closure” commands to external devices. Eight circuits are provided. In
Appendix A, refer to the “
Tally Connector” section on page 351 for details.
14. System ID — Using the Unit ID Selector, set the ID of Processor #1 to 1,
Processor #2 to
2, Processor #3 to 3. Each Processor must have a unique ID.
15. Power On — all power on instructions are covered in Chapter 6.
With all connections made, continue with Chapter 4, “
Controller Orientation” on page 97.
Note
Using the Miscellaneous Menu, you can redefine IDs using
numbers
17 - 32. In Chapter 5, refer to the “Miscellaneous
Menu” section on page 179 for details.