Instruction manual

Encore Presentation System • User’s Guide 57
3. Hardware Installation
Installation
d. Ensure that all sources are properly connected to your router(s).
e. Connect all selected router outputs to the desired M/E inputs.
9. ScreenPRO-II Connections — if your system includes one (or more)
ScreenPRO-II units as unique destinations, you can configure the ScreenPRO-II
for internal or external source routing:
a. When External routers are used, connect two outputs from an Analog
router to
any two HD-15 inputs on the ScreenPRO-II. An SDI router
can also be connected to BNC inputs
1 and 2. During setup, these
specific patches will be defined using the
Output Patch Menu.
b. When Internal routing is used, connect Analog sources to inputs 1 - 8 on
the HD-15 connectors, and SDI sources to BNC inputs
1 and 2. During
setup, these patches will be defined using the
Input Patch Menu.
10. Output Connections —
a. Connect the Processor’s analog or digital Preview Output to the input of
your Preview Monitor.
b. Connect the Processor’s analog or digital Program 2 Output to the input
of your Program Monitor.
c. Connect the analog or digital Program 1 Output to the projector input.
d. (Optional) If your system is configured with the HD/SDI output, connect
the
Program Out HD/SDI connector to an SDI or HDTV monitor, or to
the proper video distribution equipment.
11. Aux Destinations — you can configure three types of Aux destinations: Aux
(monitors), ImagePRO Aux and PresentationPRO-II Aux. Refer to Appendix D,
“
Working With Destinations” on page 367 for interconnection details.
12. Power Connection — connect AC power cords to the AC Power Connectors on
the rear of the Processor and Controller, and then to AC outlets. Connect AC
Power cords (or AC adapters) to all peripheral equipment. Please note:
~ Connect each unit only to a properly rated supply circuit.
~ Reliable grounding of rack-mounted equipment should be maintained.
13. Tally Connection — the Controller provides one 25-pin D connector for issuing
“relay closure” commands to external devices. Eight circuits are provided. In
Appendix A, refer to the “
Tally Connector” section on page 351 for details.
14. System ID — Using the Unit ID Selector, set the ID of the Processor to 1.
15. If your system includes remote destinations such as ScreenPRO-II units, refer to
Appendix D, “
Working With Destinations” on page 367 for connection details.
16. Power On — all power on instructions are covered in Chapter 6.
Please continue with Chapter 4, “
Controller Orientation” on page 97.
Note
This output will only work if the selected output resolution is a
valid SDI or HD/SDI format.
Note
Using the Miscellaneous Menu, you can redefine IDs using
numbers
17 - 32. In Chapter 5, refer to the “Miscellaneous
Menu” section on page 179 for details.