Instruction manual

Encore Presentation System • User’s Guide 309
7. Operations
Working with Layer Functions
rëáåÖ=`çéó==
The Copy function enables you to copy the properties of the active PIP or Key to another
PIP or Key — on the same (or different) mixer.
 Use the following steps to PIP or Key parameters to other layers:
1. In the Layer Control Section, select the PIP or Key that you want to "copy from"
(the blinking layer).
2. In the Layer Functions Section, press Copy to display the Copy Setup Menu.
3. Using the menu, enable or disable the specific parameters that you wish to copy
(e.g.,
Position, Size, Border, etc.). You can also enable or disable all parameters
using the {
ALL ON} and {ALL OFF} buttons.
4. Press and hold Copy.
5. Press the button for the layer that you want to "copy to."
rëáåÖ=cêÉÉòÉ
 Use the following steps to freeze a layer’s motion. Both PIPs and Keys can be frozen.
1. In the Layer Control Section, select the layer on Preview that you wish to freeze.
2. In the Layer Function Section, press Freeze. The button lights to indicate that
“freeze” is enabled.
3. Transition the frozen layer to/from Program in the normal way.
4. To restore motion to the source, select the frozen layer and press Freeze.
Please note:
• If a mixer is in Mix mode, you can only freeze and un-freeze while a layer is
selected on Preview.
• If a mixer is in Split mode, you can freeze and un-freeze while a layer is selected
on either Preview or Program.
• When Freeze is enabled for a layer, PIP and Key adjustments are not allowed.
Copy
Note
The "copy to" layer must be enabled on Preview.
Freeze
Note
The lit Freeze button indicates an association between the
selected layer and the “freeze.” If you select a different layer
that does not have an associated freeze, the button turns off.
If you return to the “associated” layer, the button lights again.